Tankless Water Heater Installation Cost in Burnaby
- The unit is rarely the biggest line item — gas line sizing, venting and condensate drainage usually drive more of the cost than the appliance itself.
- A tankless unit fires at a much higher input than a storage tank, so many Burnaby homes need a larger gas line or a rebalanced gas system before the swap is code-compliant.
- Venting is the second big variable: tankless units need their own dedicated sealed vent, and the distance to an exterior wall or roof changes the labour and material required.
- Condensing tankless models produce acidic condensate that must be neutralized and drained — where the nearest drain sits can change the install substantially.
- Permits and Technical Safety BC gas permitting are part of a legitimate installation; a quote that skips them is not cheaper, it is incomplete.
- BC Wide provides written estimates so every cost factor is visible before work begins, and financing is available.
Tankless water heater installation cost in Burnaby is set mostly by your house, not by the water heater. Two neighbours on the same block can get very different numbers for the identical model — because one has a gas line with spare capacity three metres from an exterior wall, and the other has an undersized line, a finished basement ceiling, and no nearby drain.
That is the honest answer, and it is why no reputable contractor can quote a tankless conversion accurately over the phone. What a good estimate does is make every one of those variables visible, so you can see exactly what you are paying for and where the money goes.
This guide walks through each cost driver in plain language, with attention to the housing stock across Burnaby — from the post-war homes around Burnaby Heights and East Burnaby to the newer townhomes and towers near Brentwood, Metrotown and Lougheed.
What You Are Actually Paying For
A tankless installation is really five jobs bundled together: removing the old equipment, supplying enough gas, building a new vent path, handling condensate and water connections, and getting the work permitted and inspected. When people are surprised by a tankless quote, it is almost never the unit — it is that a conversion touches more of the house than a like-for-like tank swap does.
- The equipment itself — capacity, condensing versus non-condensing, indoor or outdoor, recirculation capability
- Gas supply work — verifying, resizing or re-running the gas line so the unit’s input is properly served
- Venting — dedicated sealed vent through a wall or roof, plus any firestopping, flashing and exterior finishing
- Condensate management — neutralizer and a drain path, on condensing units
- Water piping — new supply and return connections, isolation/service valves, and often a pressure-relief termination
- Electrical — a dedicated receptacle or circuit for the unit’s controls and ignition
- Removal and disposal of the old tank, plus permits, inspection and labour
Gas Line Sizing: The Single Biggest Variable in Burnaby
A storage tank heats slowly and steadily, so it draws a modest gas input. A tankless unit has to produce all of its heat on demand, which means a much higher firing rate. That is why the gas line that comfortably fed your old tank frequently cannot feed a tankless unit at full output.
Sizing is not a guess. A licensed gas fitter looks at the total connected load of the house — furnace, range, dryer, fireplace, barbecue — plus the developed length of pipe and the number of fittings, then determines whether the existing line delivers adequate pressure and volume at the appliance under worst-case simultaneous demand.
The outcome drives cost more than anything else. Sometimes the existing line is adequate and the work is minimal. Sometimes a larger line must be run from the meter, through a finished basement or a crawlspace, and occasionally the gas meter itself needs review with your gas utility. Older homes in East Burnaby and around Capitol Hill more often need this work than newer builds in the Brentwood and Lougheed corridors.
Venting: Where the Unit Can Go Changes the Price
Tankless units cannot share the old tank’s chimney or B-vent. They require their own sealed, dedicated venting rated for the appliance, and manufacturers set strict rules on total vent length, number of elbows, and clearance from windows, doors, soffits, decks and property lines.
Practically, location dictates cost. A unit mounted on an exterior wall in an unfinished basement, venting straight out, is the simple case. A unit in a central mechanical room in a finished house, needing a long run through joists and drywall to reach daylight, costs considerably more in labour and material. Burnaby’s mix of housing makes this especially variable: a townhome or suite-converted house with limited exterior wall access, tight side yards, or restrictions on where a vent may terminate relative to a neighbouring property needs more planning and often a longer run.
Condensate, Water Quality and Service Valves
Most modern tankless units are condensing, which means they extract extra heat from the exhaust and produce acidic condensate. That liquid must be neutralized and drained. If there is a floor drain or laundry standpipe nearby, this is simple. If there is not, a condensate pump and a routed drain line add work.
Water quality matters differently here than people expect. Lower Mainland water is soft, so heavy scale is not the dominant issue it is in hard-water regions — but soft, low-mineral water is still corrosive to some components over time, and sediment from municipal work or older galvanized piping can foul a heat exchanger. Isolation and service valves are worth installing at the outset: skipping them saves very little on install day and costs more at every service visit afterward.
Access: Why Identical Homes Quote Differently
Access is the cost factor homeowners most often underestimate. Getting the old tank out and the new unit in, running new pipe, and reaching the vent termination point all take longer when space is tight — and old tanks are heavy, so a narrow stairwell or a route through a suite is real labour.
- Unfinished basement with open joists: the easiest and least expensive scenario
- Finished basement or a rental suite below: drywall access, patching and restoration considerations
- Crawlspace mechanical space: slow, physically demanding work with limited working room
- Closet or under-stair installations: clearance requirements may rule out some equipment entirely
- Townhomes and strata properties: exterior work may require strata approval, and vent termination may be restricted
- Garage installations: specific requirements around ignition source elevation and vehicle-impact protection
Permits, Code Upgrades and Inspection
Gas work in British Columbia is regulated. A tankless installation involving gas piping and venting requires permitting and inspection, and the work must be performed by licensed gas fitters. This is part of a legitimate installation cost, not an optional extra.
Beyond the permit itself, inspection can surface pre-existing conditions that must be corrected once the system is opened up — an improperly supported or undersized gas line, a vent termination too close to an openable window, or an unprotected relief line. These code upgrades are common in homes renovated over several decades. A quote that omits permitting is not a lower price; it is a smaller scope, and unpermitted gas work can complicate insurance claims and the sale of your home.
Repair, Replace or Convert: Is Tankless Worth It Here?
If your current tank is leaking from the shell, replacement is the only option — a leaking tank does not get repaired. If it is failing to heat or heating inconsistently, weigh the repair against the remaining service life you would be buying. A repair on a tank near the end of its expected life often buys a short reprieve at a meaningful cost; a repair on a relatively young unit with one isolated failed component usually makes sense.
Converting to tankless is a separate decision layered on top, and it should be about how your household actually uses hot water rather than about the technology being newer. It tends to pay off when you run out of hot water regularly, when floor space is at a premium, or when the mechanical space is being reconfigured anyway. It makes less sense when your existing tank meets demand comfortably and the gas and venting work required is extensive.
One timing note: if the tank has already failed and you were considering tankless eventually, doing it now avoids paying twice for equipment removal and mechanical work. For electric-only condos and townhomes across Burnaby, a gas tankless conversion is generally not on the table at all, and the conversation shifts to electric or heat-pump water heating where the space and drainage allow.
How to Compare Tankless Quotes Fairly
The most common mistake is comparing bottom-line numbers on quotes that describe different work. One contractor may have included a gas line upgrade and permitting; another may have assumed the existing line is fine and left permitting out.
Ask every contractor the same questions so the quotes describe the same job.
| What to ask | Why it changes the price |
|---|---|
| Has the gas line been sized for this unit’s input alongside the rest of the house? | The largest single variable; an assumption here can invalidate the whole quote |
| Is a permit included, and who arranges the inspection? | A quote without permitting is a smaller scope, not a better price |
| Where exactly will the unit mount and where does the vent terminate? | Vent length, elbows and clearances drive labour and material |
| Is condensate neutralization and drainage included? | A pump and routed drain line add work where no drain is nearby |
| Are isolation and service valves included? | Cheap now, expensive to retrofit; affects every future flush |
| Is removal and disposal of the old tank included? | Sometimes quoted separately, sometimes omitted entirely |
| Are drywall or finish repairs included, or homeowner’s responsibility? | Common gap in finished-basement installations |
| What warranty applies to parts, and separately to labour? | Very different coverage lengths; compare both, not one |
Rebates, Financing and How BC Wide Estimates the Job
Rebate programs in British Columbia — administered through CleanBC, FortisBC and BC Hydro among others — change regularly in both eligibility and value, and some target heat-pump water heating specifically rather than gas tankless. We do not publish figures, because any number correct today may be wrong next quarter. Ask us about current programs when we quote, and confirm details with the program administrator before counting on them. Eligibility commonly depends on the equipment installed, the fuel being replaced, your utility account, and whether the work is permitted and documented properly. Financing is available if you would rather spread the cost.
We look at the house before we quote a number: confirming the existing gas line and total connected load, identifying a viable vent route and termination, locating a drain for condensate, checking electrical supply, and assessing how the old tank comes out and the new unit goes in. You get that in a written estimate with the scope spelled out — equipment, gas work, venting, condensate, water connections, electrical, permitting, removal and disposal. If code upgrades are needed, they are listed rather than buried.
BC Wide Home Services has served Burnaby and the surrounding Lower Mainland since 1999, including neighbouring New Westminster, Coquitlam and East Vancouver. We are licensed and bonded, Technical Safety BC certified, and our technicians are Red Seal qualified. We are an experienced independent contractor — we are not a factory-authorized dealer — and we install and service both current and older water heating equipment. Emergency service is available, and old equipment removal is part of what we do.
Frequently asked questions
Why can’t you quote my tankless installation over the phone?
Because the price is set by your house, not the appliance. Until someone has verified whether the gas line can carry the unit’s input alongside your furnace, range and dryer, found a compliant vent route to the exterior, and located a drain for the condensate, any number is a guess. Two Burnaby homes with the same model can differ substantially. A site visit and a written estimate protect you from a mid-job surprise.
Do I always need a bigger gas line for a tankless water heater?
Not always, but often enough that it must be checked rather than assumed. A tankless unit fires at a far higher input than a storage tank because it heats water on demand. A licensed gas fitter calculates the total connected load of the home and the developed pipe length to determine whether the existing line delivers adequate volume and pressure under simultaneous demand. Older Burnaby homes need this upgrade more frequently than newer construction.
Can a tankless unit use my old water heater’s chimney or vent?
No. Tankless units require their own dedicated sealed venting rated for the appliance, installed to the manufacturer’s specifications for length, elbows and clearances from windows, doors, decks and property lines. Reusing an old chimney or B-vent is not permitted and is genuinely dangerous. The cost of the new vent depends heavily on how far the unit sits from a suitable exterior termination point.
What rebates are available for a tankless water heater in Burnaby?
Programs through CleanBC, FortisBC and BC Hydro exist and change regularly in both eligibility and value, and some are aimed at heat-pump water heating rather than gas tankless. We do not publish amounts because they go stale quickly. Ask us about current programs when we provide your estimate, and confirm the details with the program administrator directly. Proper permitting and documentation is usually a condition of eligibility.
Is a permit really required for a tankless installation?
Yes. Gas piping and venting work in British Columbia is regulated, requires permitting and inspection, and must be carried out by licensed gas fitters. A quote that leaves permitting out is not cheaper — it is a narrower scope. Unpermitted gas work can also create problems with home insurance claims and during a property sale, so it is worth doing properly the first time.
Is tankless worth it if I live in a Burnaby condo or townhome?
It depends on the building. Many condos are electric-only, which rules out a gas tankless conversion entirely. In townhomes with gas service, the deciding factors are usually whether a compliant vent termination is possible given the exterior walls and neighbouring units, whether strata approval is required for exterior work, and whether a condensate drain is reachable. We assess all three before recommending anything.
How long does a tankless installation take?
It varies with scope rather than following a fixed schedule. A straightforward replacement in an unfinished basement with an adequate existing gas line and a short vent run is a much shorter job than a first-time conversion requiring a new gas line through finished space and a long vent route. We give you the expected duration as part of the written estimate once we have seen the space, rather than promising a timeframe sight unseen.
Does soft Lower Mainland water mean I never have to flush a tankless unit?
No. Soft water reduces the heavy scale buildup common in hard-water regions, but it does not eliminate maintenance. Sediment, corrosion and debris from municipal water work or older piping can still affect a heat exchanger and filter screens over time, and manufacturers make regular flushing a condition of warranty. Installing isolation and service valves at the outset makes that annual maintenance quick and inexpensive.
BC Wide Home Services — Lower Mainland home-comfort specialists since 1999
Technical Safety BC Licensed Gas Contractor (LGA0090068) · Class B Gas Licence (CGA0028029) · Red Seal technicians · Evening and weekend calls · Diagnostic service calls $189.00 · Free in-home estimates on replacements (the $189.00 is waived if you replace with us). Call 604-473-9690 or book a free replacement estimate.
Frequently asked questions
How long does a hot water tank last?
Should I switch to a tankless water heater?
My hot water tank is leaking — is it an emergency?
What brands of water heaters do you install?
Can I install a water heater myself?
What HVAC services does BC Wide offer in Metro Vancouver?
How long has BC Wide been in business?
What areas do you serve?
What Greater Vancouver homeowners say about BC Wide
Get a Free Quote — Right From This Page
Request a Free Quote
Get Comfortable — Talk to BC Wide Today
Free, no-obligation quotes. TSBC-licensed local technicians serving Greater Vancouver since 1999.


